1. Finished fabricating the mounting system that will hold the RCP air vent, while still allowing the cover plate to be removed easily for maintenance. (The two right-side screws will fasten the vent, plenum, and backing plate to the airframe-mounted "tabs," while the two left screws will only fasten the cover plate to the vent, plenum and backing plate. This arrangement was necessary to allow the cover plate to sit flat.)
2. Installed a 4-pin Seal-All connector in the wiring for the FCP seat heat switch. Again, this is to facilitate easy maintenance of the fuel selector, or anything else below the left floor panel where the switch will be located..
3. Installed G-meter in panel, using new black screws.